Star Headlight & Lantern TDDL15 Series High Intensity - Manual (Page 4)

-2-
Limited mounting hardware is supplied because of the many mounting possibilities of
these products. The installer assumes responsibility for the integrity of the installation. It is the
sole responsibility of the owner to ensure the traffic director is secure.
Before beginning the installation:
• Determine where the Traffic Director is to be mounted (on your lightbar, on your roof,
in your rear window, etc.
• Check to see that there are no obstructions hindering the visibility of your traffic
director.
• Then select a location to mount your controller. The controller must be located in a
dry location out of direct sunlight, free of dirt and dust. Under the vehicle's
instrument panel is usually the best choice.
Once you have selected these locations, determine the path your cable, which
connects the controller to the Traffic Director, will take. If you are installing a
TDDL15-47 or TDDL15-36 the cable should exit the left side of the Traffic Director
when you are facing both the stick and the controller. If you are installing the
TDDL15-42 the cable should exit the right side of the Traffic Director when you are
facing both the stick and the controller.
• Be sure the cable attached to your Traffic Director is long enough for proper
installation. If it is too short, you will need to order a longer harness to replace the
one that came with the lightstick. Star does not recommend “splicing in”
additional cable when the supplied cable is too short (or if you damage the
original harness during installation).
Available lengths include:
15’ SWH-271-ARO-15
22’ SWH-271-ARO-22
30’ SWH-271-ARO-30
45’ SWH-271-ARO-45
60’ SWH-271-ARO-60