StorCase Technology DE100i-SWCU2 - Manual (Page 16)

Installation 9
DE100i-SWCU2 User's Guide - Rev. B02 StorCase Technology, Inc.
Figure 7: Receiving Frame Motherboard Option Pins
Installing the Receiving Frame
NOTES: DE100i-SWCU2 requires LVD chassis and cabling.
DE100i-SWCU2 supports implementations with a maximum of 9 drives.
The drive should be installed into the carrier before installing the receiving frame into the
mounting bay of a computer or expansion chassis. A #2 Phillips screwdriver will be required
for installation.
1. Turn OFF power to the computer.
2. Open the computer system according to the manufacturer’s instructions. If
necessary, temporarily remove any expansion boards that may make installation
difficult.
3. To select the DE100i-SWCU2 unit ID remotely through the computer system or
external expansion chassis, the appropriate cable from the system must be
connected to the ID Select Pins 1-8 on the rear of the receiving frame as shown
in Figure 7.