StorCase Technology DE100i-SWCU2 - Manual (Page 18)

Installation 11
DE100i-SWCU2 User's Guide - Rev. B02 StorCase Technology, Inc.
Figure 8: Receiving Frame Mounting Holes
5. Adjust the front of the receiving frame so the carrier slides freely in and out on
the receiving frame guides. The position of adjoining peripheral units may require
adjustment.
6. To connect the drive to a remote activity LED in the computer system or ex-
pansion chassis, connect the appropriate cable(s) to option Pins 9 & 10 on the
receiving frame motherboard Option Pin Connector as shown in Figure 5.
7. Connect the I/O cable from the host adapter to the receiving frame. The Pin 1
indicator on the cable must be properly aligned. Refer to Figure 5 for the correct
Pin 1 location.
NOTE: Make sure that only the last SCSI device is terminated. No
onboard termination is provided on the DE100i-SWCU2. External
termination must be provided.
4. With the drive carrier locked into place inside the receiving frame, install the
DE100i-SWCU2 receiving frame into the drive bay in the computer orexpansion
chassis. Use the appropriate guides to position the DE100i-SWCU2, and fasten
it into place with the four (4) #6-32 Phillips Pan Hd. screws provided. Figure 8
illustrates the location of the mounting holes. Mounting holes are provided on
each side and the bottom of the receiving frame to accommodate a variety of
mounting configurations. Use the mounting holes which best suit the computer
or expansion chassis configuration.