StorCase Technology DE200i-SWCU2 - Manual (Page 21)

14 Installation
StorCase Technology, Inc. DE200i-SWCU2 User's Guide - Rev. A01
Adjusting the Spin Down/Up Timer
NOTE: The timer for device spin down is controlled by a small selector, located in a cutout
on the side of the Data Express receiving frame as shown in Figure 10. The amount
of time required for a drive to spin down is approximately 15 seconds or more.
This number can vary depending on the type of SCSI device and manufacturer
(some drives may require 45 seconds or more). The factory configuration is set
for 20 seconds. A different delay time may be selected with the provided alignment
tool. Refer to the SCSI device manufacturer’s manual for more information on
required device spin down time.
Figure 10: Device Spin Down/Up Timer