1programming device codes, 2deleting device codes, 6 programming device codes – DoorKing 1817 User Manual
Page 47
3.6 PROGRAMMING DEVICE CODES
The PC programmable telephone entry system must be equipped with a MemPLUS chip to program
device codes into its memory. Device codes must be five (5) digits in length and are typically card
and transmitter codes. Each device code that you enter is assigned to the directory code that you
select. Up to 25 device numbers can be entered under a single directory code, up to a maximum of
8,000 for the system. You cannot duplicate device codes.
3.6.1 Programming Device Codes
This program sequence enters device (card, transmitter, digital) codes into the system memory.
1.
Press *70 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2.
Enter the directory code that the device code is to be assigned to (1, 2, 3 or 4 digits
depending on what was programmed in 3.5.1) then press * (beep).
3.
Enter the five-digit device code _ _ _ _ _ then press * (beep).
4.
Repeat steps 2 and 3 to enter additional device codes.
5.
Press 0# TOGETHER to end this programming step (beeeeeep).
3.6.2 Deleting Device Codes
This program sequence deletes individual device codes.
1.
Press *71 and enter the four-digit MASTER CODE _ _ _ _ (beep).
2.
Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in
3.5.1) then press * (beep).
3.
Enter the five-digit device code _ _ _ _ _ then press * (beep).
4.
Repeat steps 2 and 3 to delete additional device codes.
5.
Press 0# TOGETHER to end this programming step (beeeeeep).
47