SurgeX EV-23010 - Manual (Page 13)

User Manual
©2014 Electronic Systems Protection, Inc. /
Technical Support: 1-800-645-9721 / espei.com 12
IV. Troubleshooting
The Filter and Data Interface Cable contain no user-serviceable parts. Do not attempt
product disassembly, as this will void the product warranty.
Le filtre et le câble d'interface de données ne contiennent aucune pièce réparable par
l'utilisateur. N'essayez pas de démonter le produit, car cela annulerait la garantie du produit.
El filtro y el cable de la interfaz de datos no son piezas que un usuario pueda reparar. No
intente desarmar el producto, ya que esto anulará su garantía.
1.
enVision PCS Filter:
Symptom Possible Cause What To Do
Red LED On, Green LED Off, No
power at output. Incorrectly wired branch circuit
outlet. The LCD EVENT
MONITOR will display the nature
of the wiring fault. Contact a licensed electrician to
correct the branch circuit outlet
wiring.
Red LED Off, Green LED Off, No
power at output. No voltage or unacceptable
voltage at branch circuit outlet, or
enVision PCS
Filter output
manually turned Off.
If the LCD EVENT MONITOR is
not on, there is no power at the
wall receptacle. If the voltage is
unacceptable, the LCD EVENT
MONITOR will display the type of
voltage condition. Use the
Diagnostic Software to measure
the voltage at the wall
receptacle. Contact a licensed
electrician to troubleshoot the
wall receptacle. Use the
Diagnostic Software to manually
turn the outlets On.
Red LED Off, Green LED On, No
power at output. Defective product. Contact ESP for product
replacement at 800.645.9721.