Taser Axon-Flex - Manual (Page 15)

15
Audio Prompts
The AXON flex system emits beeping sounds called audio prompts to notify you of the system status. These audio
prompts usually occur after you perform an action with the AXON flex system.
NOTE: The camera must be connected to the controller for audio prompts to be heard. If the camera and controller
are connected and you still do not hear the audio prompts, check the camera’s volume.
Action Audio Prompt
Powering on or off One beep
Recording an event Two beeps (sound every two minutes)
Press the battery button while the camera is
recording
Two beeps
The device is ending an event and returning to
BUFFERING mode
One long beep
The battery is at 20 percent capacity or lower Four quick beeps (repeating every 20 seconds)
The system is in buffering mode No beeps
Cable disconnect (the camera will shut down) One beep
The camera’s memory is full Three beeps
5