Taser Axon-Flex - Manual (Page 16)

16
Care and Maintenance
Cleaning the AXON flex System Components
Use a soft, damp cloth to clean the surface of the system components. Do not use harsh cleaners or solvents. Do
not immerse the system components in water or cleaning solutions.
If the AXON flex camera lens becomes dirty, use a lens blower brush to clean it and then wipe it with a soft cloth
if necessary.
You may moisten the cloth with isopropyl alcohol.
• Do not use Windex or similar type cleaners on the camera lens.
• Do not place the lens under running water or apply jets of water to the camera lens.
• When the cable contacts show signs of contamination (e.g., with dirt or debris), clean them gently with a white
or red pencil eraser.
Charging the Controller Battery
A fully charged controller battery should provide enough power for approximately 12 hours of normal operation.
Recharging a battery after a 12-hour use can take up to 6 hours if you are recharging your controller from a wall outlet,
EVIDENCE.com Dock, or an ETM. Recharging could take considerably longer if you are recharging from a computer.
If the battery depletes significantly during the shift, you will hear 4 quick tones repeating every 20 seconds. This
message indicates that less than approximately 20 percent of the battery capacity remains.
Always recharge a depleted battery as soon as reasonably possible. You can use an ETM, EVIDENCE.com Dock, wall
charger, or computer (using the 2.5 mm to USB cable) to charge the battery. Using a non-TASER approved wall
charger may degrade device performance.
Do not have EVIDENCE Sync open and running on your computer when recharging an AXON flex controller
with a computer.
6