Two Notes Reload - Manual (Page 20)

Connecting the Torpedo Reload
2 LED indicators
You will find different LED indicators on the Torpedo Reload front panel:
• SIGNAL / CLIP: indicates the presence of a signal in either the DI,
REPLAY™ or SPEAKER input (green color). The LED lights up red
whenever that signal is too strong — if so, you need to lower the
volume at the corresponding input.
• MATCH™: Increase the REPLAY™ potentiometer value if the up ar-
row lights up, and lower the value if the down arrow lights up. "OK"
means that the level of the signal sent to the amplifier through the
REPLAY™ Amp Out and that of the guitar’s signal in the DI input
are at matching volumes.
• LOAD IMPEDANCE: shows the selected impedance on the Torpedo Reload. This value must
match the value of your amplifier’s speaker output. Go to the back of the Torpedo Reload and
select either 4, 8 or 16 Ohms.
NB: The Torpedo Reload must be turned off when you select the SPEAKER input impedance. Your
amplifier should not be powered on during the process.
• TEMPERATURE (Heat warning): this last indicator will light up if the temperature inside the Torpedo
Reload is too high, which activates the security load. If so, please lower the volume on your
amplifier or stop playing for some time, so the temperature decreases.
3 DI recording
This first setup is what you will use when you want to connect your instrument to your sound card
properly to do some recording and/or to feed an amp-modeler plugin. The Hi-Z (High Impedance)
instrument input of the Torpedo Reload will handle your guitar or bass signal so you face no loss of
dynamic or frequency:
1. Plug your guitar to the DI input and the DI output to your microphone preamplifier (or channel 1
on the mixer, or embedded preamplifier on your audio interface), and that preamplifier to Line
channel input 1 on your audio interface.
2. Activate Track 1 for recording & live monitoring, select channel 1 as an input.
3. Start recording!
20 Two Notes Audio Engineering Torpedo Reload