Two Notes Reload - Manual (Page 28)

Setting up Torpedo Wall of Sound
Please note that some amplifiers or preamplifiers have a "frequency
compensated" output. Such output embeds a small circuit to emu-
late a miked speaker. Please do not use this output, or deactivate the
speaker emulation if possible, to get the best of your Torpedo Wall of
Sound software.
1 Guitar or Bass 3 Audio Interface 5 Torpedo Reload 7 Guitar or Bass
2 Guitar or bass preamplifier 4 PC/MAC with Torpedo Wall of Sound 6 Guitar or bass amplifier
Please keep in mind that the overall quality of the total sound chain is
always determined by its weakest component. The best performance
will be achieved with a perfect adaptation (impedance, level...) of
your preamp or Torpedo Reload’s output signal to your audio interface.
Your guitar or bass preamplifier may not deliver true line-level signals
and may use either line, microphone, or "something in-between" sig-
nals. Make sure the signal you put in the simulation is the best one
possible so you get the most out of your Torpedo Wall of Sound.
3 Using Torpedo Wall of Sound with a software or hardware amplifier
emulator
You may want to use Torpedo Wall of Sound in order to replace the speaker simulation of a plug-in or
hardware amplifier emulator. This may be a good idea, if you keep in mind the two cases you may
encounter and follow our recommendation:
28 Two Notes Audio Engineering Torpedo Reload