Datalogic Scanning 00A0LS-1N1-MEN0 - Manual (Page 13)

INTRODUCTION
1
5. Lock the card into place by pushing the cardholder down and then shifting
it to the right:
6.
First insert the bottom and then the upper (contacts) side of the battery
pack into the slot and press it back until the battery latch is automatically
closed.
1.4.1 Removing the Micro SD Card
To remove the Micro SD card, follow the steps above to access the SD area,
and remove it from its slot.
CAUTION
Follow proper ESD precautions to avoid damaging the SD.
Proper ESD precautions include, but are not limited to, working
on an ESD mat and ensuring that the operator is properly
grounded.
Do not force the card. If you feel resistance, remove the card,
check the orientation, and reinsert it.
Do not use the Micro SD card slot for any other accessories.
5