UVP TB-101 Selector Switch - Manual (Page 3)

6. Inside the unit, locate the side reflector panels which are two reflective metal panels located
at each end of the transilluminator light tubes. Note how these panels are installed prior to
removal, as this will aid with reinstallation later on.
7. Pulling straight up, remove the two side reflector panels from inside the transilluminator.
8. Looking inside the front panel of the transilluminator body, locate the back side of the
transilluminator selector switch. Trace the wires from the back of the switch to the gray
wiring junction block located at the front-left corner of the unit. Note which wires are
connected from the switch to the junction block.
Side
Reflector
Panel
Back Side of
Selector
Switch