UVP TB-101 Selector Switch User Manual
Page 8
8. Route the wiring from the selector switch to the
gray wiring junction block. Using a flat-
head screwdriver, press in on the gray square while pushing the metal portion of the wire into
the corresponding hole (refer to the notes from Step 9 in the “Removal Procedure” to
determine where each wire should be installed). Repeat this process until all wires leading
from the selector switch to the junction block are installed.
Note: When a wire is fully installed, the gray square will remain in the “pushed in” position
and the wire will stay snugly in place.
9. Using a soft cloth, clean any fingerprints or other dirt off of the surface of the side reflector
panels prior to reinstallation.
Side
Reflector
Panel
Gray Wiring
Junction
Block