Desa SPC-21PHTSA - Manual (Page 5)

www.desatech.com 114082-01C 5
PRODUCT
IDENTIFICATION
Figure 1 - Propane/LP Table Top Patio
Heater
Dome
Reflector
PRODUCT FEATURES
SAFETY PILOT
This heater has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shutoff system. The
ODS/pilot is a required feature for table top patio
heaters. The ODS/pilot shuts off the heater if there
is not enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system re-
quires no matches, batteries, or other sources to
light heater.
UNPACKING
1. Remove heater from carton.
2. Remove all protective packaging applied to
heater for shipment.
3. Check heater for any shipping damage. If
heater is damaged, promptly return to dealer
where you bought heater.
ASSEMBLY
INSTRUCTIONS
Tools Required:
• Phillips Head Screwdriver
• Standard Pliers
Inspect heater components for possible shipping
damage. If any is found, immediately notify the
dealer. Check to make sure that all components are
included with your heater (see pages 12 and 13).
1. Attach burner and controls assembly to base
assembly with 4 screws (see Figure 3). Tighten
screws. Place operating instruction label under
control knob for easy review.
2. Align 3 dome holes with the 3 studs protruding
from burner top (see Figure 3). Place dome
onto the studs. Install 3 cap nuts onto studs.
Tighten with pliers.
The installation must conform with local codes or
in the absence of local codes, The National Fuel
Gas Code, ANSI Z223.1.
Figure 3 - Heater Assembly Figure 2 - Clearances from Combustibles
16"
(40.64 cm)
Wire
Guard
Propane/LP
Cylinder
Housing
Base
Control
Knob
16"
(40.64 cm)
16"
(40.64 cm)
30" (76.20 cm)
Below Burner
Dome
Reflector
Cap Nuts
Burner and
Controls
Assembly
Base
Assembly
Screws