Voodoo Lab Pedal Power MONDO - Manual (Page 6)

- 4 -
All 9V outputs can also power ordinary low-current battery operated pedals.
(3) 9V and 12V high-current output pairs. Each pair is an isolated output section
providing up to 400mA.
Note: The 9V and 12V outputs within a pair are not isolated from each other. It is
preferred to use only one from each pair. If using both, combined output should not
exceed 400mA.
(4) 9V high-current outputs. Use for all devices which require 400mA or less.
(5) 9V (or 12V) outputs. Use for all pedals which operate from a 9V battery or
require less than 100mA. Switchable to 12V via DIP switches.
(6) 9V (or L6) outputs. Use with 9V battery or high-current effects that require
less than 250mA. Switchable to L6 mode (unregulated 12V) via DIP switches.
(7) 9V (or SAG) outputs. Use for all pedals which operate from a 9V battery or
require less than 100mA. Allows you to SAG voltage from 9V down to about 4V.
Enable SAG control via DIP switches.