Voodoo Lab System Mix - Manual (Page 10)

8
D I G I T A L M U S I C C O R P O R A T I O N
1. The guitar is connected to the amp or preamp input. The preamp output or amp effect send is
connected to the Left input of Mix 1 In 1. The passive split sends copies of the preamp signal
to the mono inputs of the effects devices.
2.
The stereo outputs of the effects are brought back to the
mixer to be blended with the original preamp tone. For FX 1 and 2,
we will use In 2 and In 3 of Mix 1. Remember, Mix 2 In 1 is being
used by the internal connection with Mix 1. These effects will be
blended in parallel with the original preamp tone.
3.
Next, the two stereo Mix 1 Outs are used to drive the
second stage effects. FX 3 and 4 will be affecting all of Mix 1 (the preamp signal and the
outputs of FX 1 and 2). Remember, the Mix 1 signal is also sent to Mix 2 via the internal
connection. The stereo outputs of FX 3 and 4 are brought back to the mixer (In 2 and In 3 of
Mix 2) to be blended with the original Mix 1 signal.
4. Mix 2 Outs are connected to the power amp input, or the amp effect return.
In this example, the Mix 1 knob controls the level of the preamp and FX 1 and 2. The Mix 2
knob controls the level of the entire mix. Please refer to Section 3.3 to correctly set levels.