Vortech 2005-2008 Ford 4.0L V6 Mustang - Manual (Page 11)

P/N: 4FU020-610
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
06AUG08 v4.1 05MusV6(4FU..610v4.1)
1
A. Disconnect the mass air flow (MAF) sensor
plug. Remove the MAF sensor from the facto-
ry inlet duct and set it aside (with the original
screws) for later use. (See Fig. 1-a.)
B. Disconnect the crankcase vent line where it
attaches to the driver’s side valve cover.
C. Remove the factory air filter housing and inlet
duct up to the throttle body. (See Fig. 1-a.)
D. Drain and remove the power steering reser-
voir. The reservoir will be relocated during a
later step.
E. Remove one of the three bolts from the
power steering pulley. Replace it with one of
the supplied M8-16mm bolts. (Do not use a
washer.) Repeat step for the two remaining
power steering pulley bolts. (See Fig. 1-b.)
F. Using a 3/8" ratchet, compress the accessory
belt spring tensioner and remove the belt
from the vehicle.
1. PREPARATION/REMOVAL
Fig. 1-a
Fig. 1-b
AIR
FILTER
HOUSING
CRANKCASE VENT
LINE
MAF
SENSOR
REPLACE
BOLTS