Vortech 2000-2003 Ford Focus Zetec/SVT - Manual (Page 15)

P/N: 4FJ020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
19APR04 v3.0 Focus(4FJ v3.0)
3
A. Locate the oil pressure sender on the back of
the engine block near the oil filter. Remove
the oil pressure sender.
B. Lightly lubricate the threads of the supplied
1/8" NPT street fitting with engine oil. Install
the street fitting into the block.
C. Install the oil pressure sender into the street
fitting so that it is pointing upward and parallel
with the egine block.
D. Install the 1/8" NPT to -4 fitting into the end of
the street fitting so that it is perpendicular to
the engine block. (See Fig. 3-a.)
E. Install the 90° end of the feed hose to the -4
fitting and route it close to the block and up to
the supercharger mounting location.
F. Install the electronic plug back onto the oil
pressure sender.
3. SUPERCHARGER OIL FEED
Fig. 3-a
A. Locate the coolant manifold running across
the top/front of the radiator support. Remove
the plastic manifold and disconnect the three
coolant lines running to the manifold. (See
Fig. 4-c.)
B. Cut 1" off the end of each coolant line run-
ning to the manifold.
C. Modify the plastic coolant manifold by grind-
ing both tabs so that they are flush with the
manifold. (See Fig. 4-a.)
D. Reattach the lines to their original manifold
ports. (Cutting the lines allows for the coolant
manifold to sit lower.)
E. Tuck the manifold between the top of the radi-
ator and the upper radiator support. This will
allow for clearance between the drive assem-
bly and the coolant manifold. (See Fig. 4-b.)
4. CROSSOVER COOLANT LINE MODIFICATION
Fig. 4-a
Fig. 4-b
Fig. 4-c
1/8"NPT TO -
4 FITTING
STREET
FITTING
2 AREAS TO GRIND
COOLANT MANIFOLD
IN RELOCATED
POSITION
STOCK COOLANT
MANIFOLD LOCATION