Vortech 1986-1993 Ford 5.0 Mustang - Manual (Page 20)

P/N: 4FA020-010
© 2009 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
16APR09 v4.1(86-93 5.0 Mus (4FA v4.1))
8
7. MAIN BRACKET ASSEMBLY
Assemble the main bracket, plate and other
parts necessary to relocate the alternator
and smog pump and make room for the
supercharger. For 1992 and later vehicles,
please review points A through H before
starting.
A. Measure the length of the pivot boss on
the alternator and record. It should be very
close to 3".
B. In a similar manner, measure the boss on
the smog pump. When combined with the
.920" spacer, it should be 4.050". Record
these measurements so that in the event
of a belt alignment problem, Vortech can
properly advise you.
C. Place the smog pump and alternator on
the large aluminum mounting bracket as
shown. After making sure the 6 1/4" bolts
have a washer on them, enter the cast
mounting bracket from the rear (coming
towards you). Place the .920" tube spacer
over the bolt on the smog pump. Lower
supercharger mounting plate over bolts.
The idea is to sandwich the alternator
and smog pump between the mounting
bracket and plate. Place washers and nuts
on the 6-1/4" bolts and finger tighten. For
vehicles equipped with alternators having
larger 7/16" pivot bolts, it will be necessary
to enlarge the corresponding hole in the
plate.
D. Start the 3/8-16 x 1" fastener with a washer
at the top of the bracket and finger tighten.
Insert the 6-1/2" and 7" bolts. These bolts
will later hold assembly to engine.
S.H.O./RENEGADE V-7
KIT ONLY
NOTE: Remember to place the .920"
spacer between the smog pump
and mounting plate.
1986-93 S.h.O./RENEGADE
V-7 KITS ONLY
NOTE: The upper mounting bolt boss
on the smog pump (if equipped)
requires grinding to allow for
fitment of the V-7 compressor
(see Fig. 7-b).
*
V-7 application with aluminum
mounting plate requires 6-3/4" and
7-1/4" bolts.
Fig. 7-a
Fig. 7-b
3/8-16x1"
MOUNTING PLATE
3/8-16X1-3/4"
7/16-14 x 1-3/4"
3/8-16 x 6-1/2"
3/8-16 x 7"
3/8-16 x 6-1/4"
install from rear
ALTERNATOR
ALTERNATOR STAY
3/8-16 x 1"
3/8-16 x 3/4"
3/8-16 x 2"
3/8-16 x 6 1/4"
install from rear
place .920" spacer
SMOG PUMP
& PULLEY
3/8-16 x 6 1/4”
and place .920 spacer
between plate and pump
install from rear
(6-3/4” *)
(7-1/4” *)
MOUNTING BRACKET