Vortech 1986-1993 Ford 5.0 Mustang - Manual (Page 21)

P/N: 4FA020-010
© 2009 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
16APR09 v4.1(86-93 5.0 Mus (4FA v4.1))
9
8. SMOG PUMP HOSES
A. Separate the short hose and bent hose from the
air control valve and place the shorter hose on
the diverter valve (the valve closest to the firewall)
as shown.
B. Connect the air control valve to the short hose.
C. Trim approximately 1-1/2", or as necessary, off
the longer straight portion of the bent hose for
proper fit.
D. Secure the hose as shown with the stock
clamps.
E. It may be necessary to reroute the vacuum control
line after the supercharger is in place.
E. Attach the Vortech alternator brace between
the boss on the smog pump and alternator
with the 3/8-16 x 1" bolts. On 1992 and later
Mustangs, it may be necessary to drill and
tap the "blanked" hole in the smog pump.
To accomplish this use an R size bit and a
3/8-16 size tap.
F. Tighten all fasteners in the bracket/accessory
assembly.
G. Lower the entire assembly into position and
start all four fasteners that hold it to the
engine. Tighten all fasteners in a progressive
manner.
h. Reconnect alternator wires and use a tie
wrap to secure the wires.
7. MAIN BRACKET ASSEMBLY (cont'd.)
1986-93 RENEGADE
5.0L KIT ONLY
NOTE: Due to the location of the Vortech
Mondo bypass valve, removal of
the air injection hose assemblies
is required for proper bypass valve
installation. This modification is for
off-road use only. Disregard the fol-
lowing steps A thru E.
Fig. 8-a
SMOG PUMP
DIVERTER VALVE ALVE AIR CONTROL V
SHORTEN THIS HOSE 1-1/2”