Vortech 1991-1994 Ford 4.0L Ranger/Explorer - Manual (Page 10)

P/N: 4FD020-010
©2001 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
31JUL01 V1.1
(Explorer/Ranger(4FD V1.1))
FORWARD
SPACER
BRACKET
11mm
DOWELS
4. MOUNTING BRACKET INSTALLATION
A. With the air conditioning compressor tempo-
rarily moved off to one side, install the two
Vortech supplied 11mm dowel sleeves into the
air conditioning compressor mount. (See
Fig.
4-a.)
B. Position the spacer and bracket on the air con-
ditioning compressor mount as shown. (See
Fig. 4-b.)
C. Remove the factory dowel sleeves from the
bottom of the air conditioning compressor and
set aside. Install the compressor on top of the air
conditioning mount and brackets.
D. Install the factory dowel sleeves into the Vortech
aluminum adapter bracket and install the bracket
on top of the air conditioning compressor. Insert
the four supplied 8mm x 150mm bolts and AN
washers. Start all bolts before tightening in a
crisscross sequence. Make sure all dowels and
brackets are aligned properly. (See
Fig. 4-c.)
E. Using the supplied tie wraps, resecure the left
side air conditioning line to prevent contact with
the power steering pump or brake lines.
F. Install the supercharger mounting plate using
four 3/8-16 x 1" bolts, four AN washers, two 3/8"-
16 nuts and two 3/8" lock washers.
G. Reroute and install air conditioning clutch wiring
connector. (See Fig. 4-d.)
11mm
DOWELS
4
Fig. 4-a
Fig. 4-b
Fig. 4-c
Fig. 4-d
NOTE: If your vehicle has gone over 10,000
miles since its last spark plug change,
you will need to change the spark plugs
now before test driving the vehicle.