Vortech 1991-1994 Ford 4.0L Ranger/Explorer - Manual (Page 17)

P/N: 4FD020-010
©2001 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
31JUL01 V1.1 (Explorer/Ranger(4FD V1.1))
11. FINAL REASSEMBLY & CHECK
A. Reconnect the battery.
B. Check all fittings, nuts, bolts and clamps for
tightness. Pay particular attention to oil and fuel
lines around moving parts, sharp edges and
exhaust system parts. Make sure all wires and
lines are properly secured with clamps or tie
wraps.
C. Check all fluid levels, making sure that your
tank(s) is filled with 92 octane or higher fuel
before commencing test drive.
D. Start engine and allow to idle a few minutes,
then shut off.
E. Recheck to be sure that no hoses, wires, etc. are
near exhaust headers or moving parts and for
signs of any fluid leakage. Check ignition timing
to make sure it is set to stock specifications
before commencing test drive.
F. PLEASE TAKE SPECIAL NOTE: Operating
the vehicle without all of the subassemblies
completely and properly installed may cause
FAILURE OF MAJOR ENGINE COMPO-
NENTS.
G. Test drive the vehicle.
H. Read the STREET SUPERCHARGER SYS-
TEM OWNER'S MANUAL AND WARRANTY
REGISTRATION FORM within thirty (30) days
of purchasing your supercharger system to
qualify.
11
Fig. 11-a
WARNING: Do not attempt to operate the
vehicle until ALL components
are installed and ALL operations
are completed including the fi-
nal check.