Vortech 1987-1996 Ford 5.0L/5.8L Truck/SUV - Manual (Page 11)

P/N: 4FC020-010
©2000 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
13SEP00 V1.3 (86-93 5.0 Lt Truck(4FC))
1. COMPONENT REMOVAL
A. Remove the following:
1. intake air duct
2. air filter box cover & inlet hoses
3. accessory drive belt
4. cooling fan & fan shroud
5. water pump pulley
6. crank pulley
7. power steering pulley (using a pulley)
B. Remove the A/C compressor from the mount-
ing bracket and secure to one side.
C. Remove the power steering pump from the
bracket.
D. Remove the cast bracket from the engine
and save the fastening hardware.
2. OIL FEED LINE INSTALLATION
A. Remove the oil pressure sender from the
engine block (located just ahead of the oil
filter).
B. Screw the 1-1/2" long 1/4" pipe nipple into
the block, then the 1/4" pipe TEE onto the
nipple.
C. Position the TEE so the branch faces for-
ward. Screw the original pressure sender
into the branch.
D. Screw the 1/4" pipe/flare fitting into the end
of the TEE as shown. (See Figure 2-a .)
E. Install the Vortech supplied oil line onto the
flare fitting. Cover the loose end with a
plastic bag for later.
NOTE: Keep all oil fittings and hoses
absolutely clean. Use Teflon
paste sparingly only on the male
pipe threads only. NEVER use
Teflon tape. Apply only motor oil
to flare fittings. Never over-
tighten fittings.
NOTE: When removing the power
steering pump and A/C
compressor, do not break any
lines; just set the unit aside.
1
Figure: 2-a
FRONT