Vortech 1987-1996 Ford 5.0L/5.8L Truck/SUV - Manual (Page 12)

P/N: 4FC020-010
©2000 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
13SEP00 V1.3
(86-93 5.0 Lt Truck(4FC))
3. OIL DRAIN FITTING
A. Remove the driver's side valve cover.
B. Measure 4-3/4" forward from the middle of
the center bolt hole and up 3/4" from the
flange as shown on the inboard side of the
valve cover and mark. (See
Figure 3-a .)
C. Make an 11/16" diameter hole at the mark
using a drill or chassis punch. Debur the hole
completely. Thoroughly clean the valve
cover.
D. Install the 1/2" hose fitting into the elbow and
tighten.
E. Insert the elbow fitting through the hole in the
valve cover so the hose fitting points for-
ward. Secure with the special sealing nut
provided in the kit. Make sure to place the
sealing side of the nut against the valve
cover surface.
F. Reinstall the valve cover.
4. CRANKSHAFT PULLEY
A. Remove the crankshaft pulley from the
engine.
B. Place the Vortech provided crank pul-
ley spacer and crank pulley into the
stock pulley just removed. (See
Figure
4-a .)
C. Make sure the pulleys are properly
centered. Reinstall as a unit using the
3/8-16 x 2 3/4" bolts and washers
provided.
5. MAIN BRACKET INSTALLATION
A. Mount the Vortech main mounting bracket
to engine using the original fasteners.
B. Remount the power steering pump to the
new bracket using the original fasteners.
C. Reinstall the air conditioner compressor to
the new bracket using the original fasteners.
(See
Figure 5-a .)
NOTE: On certain models, the Vortech mounting bracket may need
to be redrilled and tapped to accommodate the M10 x 1.25
threads for the air conditioning mount.
NOTE: For 5.0 applications, the water pump
bolt/stud must be modified. Remove
the bolt that is one bolt clockwise
from the top center water pump
bolt. Cut off the stud portion and
reinstall the water pump bolt for
mounting bracket clearance.
2
Figure: 3-a
Figure: 4-a
Figure: 5-a
LEFT
VALVE
COVER
OIL
FILLER
FRONT OF ENGINE
UP 3/4"
FROM FLANGE
FORWARD FROM
HOLE 4-3/4"
FORWARD FROM
HOLE 4-1/2"
FACTORY PULLEY
SPACER NEW ADDITIONAL PULLEY
3 BOLTS: 3/8-16 x 2-3/4”