Vortech 2005-2008 C6 Corvette - Manual (Page 13)

P/N: 4GS020-010
©2009 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
12MAY09 v3.1 05-08Corvette(4GSv3.1)
4
A. Remove the factory M16 socket head oil gal-
ley plug on the driver’s side of the engine.
B. Using the supplied crush washer, install the
supplied M16 to –4 adapter into the engine
block.
C. Connect the 90º end of the supplied oil feed
hose to the fitting and tighten.
D. Temporarily cover the open end of the oil
feed line to protect it from debris until con-
necting it to the supercharger.
E. Use tie-wraps to secure the line and protect it
from kinking, abrasion, and high heat areas.
4. OIL FEED LINE INSTALLATION (ENGINE OIL-FED KITS ONLY. APPLICATIONS
WITH A V3 SUPERCHARGER SKIP AHEAD TO STEP 5)
Fig. 4-a
chips. Apply a small amount of silicone sealer
to the new threads. Apply more sealer to the
3/8"NPT hose fitting and secure in hole.
Make sure a seal is formed all around the fit-
ting.
G. Temporarily cover oil drain barb fitting to keep
out debris.
H. Drain the engine oil (if needed), install a new
filter and refill with fresh oil
Fig. 3-b (C6)
1-1/2"
1-1/2"
NOTE: The oil feed will be routed forward and
across the front of the engine before being
connected to the supercharger.
3. OIL DRAIN LINE INSTALLATION, CONT’D (ENGINE OIL-FED KITS ONLY.
APPLICATIONS WITH A V3 SUPERCHARGER SKIP AHEAD TO STEP 5)