Vortech 2004 Pontiac GTO - Manual (Page 26)

18
P/N: 4GJ020-010
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
28SEP04 v1.0 GTO(4GJ020-010v1.0)
12. WATER RESERVOIR/SETRAB COOLER INSTALLATION
Fig. 12-a
Fig. 12-b
Fig. 12-c
A. Locate the supplied water reservoir. Using
thread sealant install a Ø3/4" 90° brass fitting
into the 1/2NPT hole at the top of the reser-
voir. Install another 90° fitting into the bottom
1/2NPT hole.
B. Install a 2" piece of Ø3/4" hose on the top
90° fitting. Secure it with a supplied nylon
ratchet clamp and orientate it so that it will be
pointing to the passenger side. Orientate the
bottom fitting so that it will be pointing to the
driver side. (See Fig. 12-a.)
C. Secure the upper mounting bracket to the
1/4-20 threaded insert in the top of the reser-
voir. Mount the lower bracket on the drivers’
side of the tank. Use the supplied 1/4-20 x
.75 SHCS to secure the brackets. (See Fig.
12-a.)
D. Place the reservoir and brackets into their
location behind the front bumper on the far
passengers side. Mark for drill locations. (See
Figs. 12-b, 12-c.)
E. Remove the reservoir and brackets. Use a
self tapping screws to drill the upper hole.
Remove the screw after the hole is started.
For the lower mounting location use a .280"
drill to make a mounting hole in the lower
cross member. (See Figs. 12-b,12-c.)
F. Reinstall the reservoir and secure the upper
bracket with the supplied sheet metal screw.
G. Install the Ø3/4" 90° brass fittings into the top
of the supplied Setrab water cooler. Orientate
the fittings as shown in Fig. 12-d. Install the
cooler to the right of the water reservoir. The
passenger side of the water cooler will share
a mounting hole with the lower bracket of the
water reservoir. (See Fig. 12-e.)
H. Secure the passenger side of the Setrab
cooler and the bottom reservoir bracket to the
cross member with the supplied 1/4-20 x
1"SHCS.
I. Mark the driver side location of the Setrab
cooler and drill with a .280 drill. Secure the
driver side of the cooler with the supplied 1/4-
20 x 1" hardware. Make sure when mounting
the Setrab cooler that you use the rear set of
holes so that the cooler sits forward when
mounted.
UPPER MOUNTING BRACKET
LOWER MOUNTING BRACKET
UPPER MOUNT LOCATION TO DRILL
LOWER MOUNT LOCATION THAT THE
WATER COOLER AND RESERVOIR
ARE TO SHARE