Vortech 1996-1998 Ford 4.6L Mustang Cobra - Manual (Page 3)

Installation Instructions
Vortech Maxflow Power Cooler
Congratulations on selecting the best performing and most
efficient aftercooler today... the Vortech ® Maxflow Power Cooler!
The Vortech Maxflow Power Cooler system was designed as a street/strip oriented aftercooler,
specifically for use on 1996 - 1998 Ford 4.6 Mustang vehicles equipped with a Vortech supercharger
producing up to approximately 580 horsepower.
As with any power enhancing product, this system is intended for use on healthy, well-maintained
engines. Vortech Engineering is not responsible for engine damage. Installation on new vehicles
will not harm or adversely affect the break-in period so long as factory break-in procedures are
followed.
For best performance and continued durability, please take a note of the following key points:
1. Use only premium grade fuel 92 octane or higher (R+M/2).
2. Always listen for any sign of detonation (pinging) and discontinue hard use (no boost) until
problem is resolved.
1996 - 1998 Ford 4.6 Mustang Cobra (4 Valve)
TOOL & SUPPLY REQUIREMENTS
• Open End Wrenches
(7/16”, 9/16”, 5/8”, 11/16”)
• 3/8” Ratchet
• 8mm, 13mm, 9/16”and 18mm Sockets
• 5/32”, 3/16”, 9/16” Allen Wrenches
• Flat #2 Screwdriver
• Phillips #2 Screwdriver
• Utility Knife
• Wire Cutters, Strippers and Crimpers
• Drill Motor
• 1/8”, #21 Drill Bits
• Tape Measure
• Pipe Tape (Teflon)
• Adjustable Wrench
IMPORTANT NOTE: If the vehicle still has the battery located in the factory position, it must be
relocated into the trunk to make room for the water tank assembly. Vortech part number
8N150-010 is a Heavy-Duty Battery Relocation Kit that may be purchased separately. Commonly
available “universal” relocation kits may be used but they will most likely contain a smaller cable.
Additional fabrication may also be necessary when using a “universal” kit.
Before beginning this installation,
please read through this entire instruction booklet
© 1999 VORTECH ENGINEERING, INC.
All Rights Reserved, Intl. Copr. Secured