Vortech 1996-2004 Ford 4.6L Mustang GT - Manual (Page 5)

P/N: 8N020-030
© 2002 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
23JAN00 V2.1 (2V Maxflow Power Cooler.qxd)
v
Vortech Maxflow Power Cooler
Installation Instructions
1996 - 2001 Ford 4.6 Mustang GT (2 Valve)
Before beginning this installation,
please read through this entire instruction booklet
The Vortech Maxflow Power Cooler system was designed as a street/strip orient-
ed aftercooler, specifically for use on 1996 - 2001 Ford 4.6 Mustang vehicles
equipped with a Vortech supercharger producing up to approximately 580 horse-
power.
As with any power enhancing product, this system is intended for use on healthy,
well-maintained engines. Vortech Engineering is not responsible for engine dam-
age. Installation on new vehicles will not harm or adversely affect the break-in
period so long as factory break-in procedures are followed.
For best performance and continued durability, please take a note of the following key points:
1. Use only premium grade fuel 92 octane or higher (R+M/2).
2. Always listen for any sign of detonation (pinging) and discontinue hard use (no boost)
until problem is resolved.
TOOL & SUPPLY REQUIREMENTS:
• Open End Wrenches (7/16”, 9/16”, 5/8”, 11/16”)
• 3/8” Ratchet
• 8mm, 13mm, 9/16”and 18mm Sockets
• 5/32”, 3/16”, 9/16” Allen Wrenches
• Flat #2 Screwdriver
• Phillips #2 Screwdriver
• Utility Knife
• Torque Wrench (in/lbs)
• Wire Cutters, Strippers and Crimpers
• Drill Motor
• 1/8”, #21 Drill Bits
• Tape Measure
• Ford Springlock 3/8” Fuel Fitting
Disconnect Tool
• Pipe Tape (Teflon)
• Adjustable Wrench
Congratulations on selecting the best performing and most
efficient aftercooler today... the Vortech Maxflow Power Cooler!