Preparation and removal – Vortech 1996-2004 Ford 4.6L Mustang GT User Manual
Page 9
P/N: 8N020-030
© 2002 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured.
23JAN00 V2.1 (2V Maxflow Power Cooler.qxd)
1
1. Preparation and Removal
A.
Disconnect and remove the battery (if located in
the factory position, the battery will need to be
relocated to the trunk).
B.
Remove the supercharger discharge tube and
bypass valve assembly.
C.
Remove belt, supercharger and bracket.
Disassemble the bracket from the supercharger.
D.
Disconnect lines from the air inlet that connects to
the idle air control and valve cover vent.
E.
1996-1998 Models Only: Remove the FMU from
the inner fender and disconnect the male fuel line
from the fuel rail.
NOTE: Temporarily cap oil feed and oil drain to
protect your engine from foreign particles.
*
*
*
*
* Ignore these steps and refer to the supercharger kit
instruction manual if the Power Cooler is being installed
at the same time as the supercharger kit.