Vortech Universal Battery Relocation - Manual (Page 6)

P/N: 007079
©2004 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
28JAN04 v1.0 BattRelocRoutng(7079v1.0)
®
ENGINEERING, LLC
1650 PACIFIC AVENUE • CHANNEL ISLANDS, CA 93033-9901 • (805) 247-0226
FAX (805) 247-0669 • www.vortechsuperchargers.com • M-F 8:00 AM - 4:30 PM PST
3
vertical tabs off of the hold-down bracket
depending on your battery.) Secure the sup-
plied battery hold-down bracket using 3/8-16
nuts and washers. Attach the clear hose end
to the plastic 90
°
fitting mounted on the side of
the battery box. ( Refer back to Fig. 5 .)
P. Trim the power and ground cables to desired
length, cut back the insulation and install the
supplied battery end terminals. Use the sup-
plied 1-1/2" heat shrink tubing to cover any
bare metal surfaces on the cable/terminal
connections. (
See Fig. 6 .)
Q. Connect the supplied battery terminals to the
battery. Install the supplied battery box lid and
secure with the supplied washers and wing
nuts. Using a hacksaw, cut the all-thread to
where there is 3/4" of thread exposed above
the wing nuts. (
See Fig. 7 .)
R. Reinstall the trunk carpeting and interior trim
pieces. From beneath the vehicle, secure the
end of the clear hose away from the exhaust
and any moving or sharp components. (
See
Fig. 8 .)
BATTERY RELOCATION AND CABLE ROUTING, cont’d.
Fig. 6
Fig. 7
Fig. 8