Vortech Universal Carburetor Enclosure User Manual
Page 5
P/N: 007051
©2000 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
11SEP00 V 1.0
(Carb-Enclosure 007051)
A. Relieve the fuel pressure in the system.
B. Remove the carburetor from the intake manifold.
C. Thoroughly clean the intake manifold carburetor
flange.
D. Thread the four supplied carburetor flange studs
into the intake manifold.
E.
Install a new carburetor gasket.
F.
Install the lower part of the carburetor enclosure
over the studs until it sits flat on the intake
manifold.
G. Install a new carburetor gasket over the studs
until it sits flat on the carburetor enclosure carbu-
retor mounting surface.
H. With the carburetor in a suitable work area, bend
the damper tab on the main throttle arm until it is
flat. (See
Figs. 2, 3, 4.)
I.
Install the throttle nut through the large hole on
the outside of the throttle arm. Using a 10-24 cap
screw inserted through a rod end and the #10
fender washer, thread into the throttle nut and
tighten. (See
Figs. 5, 6.)
CARBURETOR ENCLOSURE INSTALLATION
1
Fig. 2
Fig. 3
Fig. 5
Fig. 4
Fig. 6