Vortech 1996-2000 SOHC VTEC Fuel Rails - Manual (Page 2)

P/N:007053
©2000 Vortech Engineering, Inc.
All Rights Reserved. Intl. Copr. Secured
12JUL00 V 1.0
2
12. Install the fuel line, sealing washers and nut in the original
configuration and torque to 22N/m (16lb/ft).
13. Connect the vacuum line and fuel hose to the fuel
pressure regulator. Reconnect the battery and check to
ensure all fittings are tight and all hoses are properly
routed and connected.
14. Turn the ignition switch on, but do not operate the starter.
After the fuel pump has run for approximately two sec-
onds, the fuel pressure in the fuel line will rise. Repeat this
two or three times, then check for any possible fuel leaks.
Torque specifications:
• Mounting tabs and fuel pressure regulator - 12N/m
(8.7lb/ft)
• Banjo sealing nut - 22N/m (16lb/ft)
®
ENGINEERING, INC.
1650 PACIFIC AVENUE • CHANNEL ISLANDS, CA 93033-9901 • (805) 247-0226
FAX (805) 247-0669 • www.vortechsuperchargers.com • M-F 8:00 AM - 4:30 PM PST