Waldorf Blofeld Keyboard - Manual (Page 56)

Sound Parameter
Blofeld User´s Manual 56
Sustain 2 0...127
Sets the second Sustain level. As soon as this level is
reached, the envelope goes into the Release phase. This
parameter affects the envelope types ADS1DS2R, One
Shot, Loop S1S2 and Loop All only.
Envelope 3 und 4
The following parameter are valid for the Envelopes 3 and
4 which offers the same parameters.
Trigger normal/ single
Determines the triggering of the Envelopes 3 and 4.
• normal means that every Note starts the envelope
of its own voice.
• single means that the envelopes of all voices of a
selected program behave like a single envelope.
This common envelope starts as soon as the first
note is played. The sustain level remains until the
last note is released. Afterwards the release phase
is active.
single is only active in monophonic
voice-mode.
Mode ADSR / ADS1DS2R / One Shot / Loop S1S2 /
Loop All
Switches between the various envelope types. Please refer
to the Appendix for detailled explaination of all the types.
Attack 0...127
Determines the attack rate or amount of time it takes for a
signal to go from zero to Attack Level.
Attack Level 0...127
Controls the level at which the Attack phase ends and the
Decay
phase starts.
Decay 0...127
Determines the Decay rate or amount of time it takes for
a signal to reach the Sustain level. This phase is also
used in the loop to go from Sustain 2 to Sustain.
Sustain 0...127
As soon as the Sustain level is reached, the envelope
proceeds with the second Decay/Sustain pair as
explained below.