Waldorf Blofeld Keyboard - Manual (Page 68)

Sound Parameter
Blofeld User´s Manual 68
Overdrive 0…127
Controls the amount of distortion of the signal. Please
note that the signal might become a little louder when
you increase this parameter.
Drive Curve
Determines the character of the drive. The following drive
curves are available: Clipping, Tube, Hard, Medium, Soft,
Pickup 1, Pickup 2, Rectifier, Square, Binary, Overflow,
Sine Shaper, Osc 1 Mod.
Sample & Hold 0...127
Controls the output sample rate. 44.1kHz means that the
signal is unaffected, while other values reduce the sample
rate of the sound to the respective rate. You will hear a lot
of aliasing when you lower the sample rate, but this is
great for so-called “lo-fi” sounds.
Chorus Mix 0…127
Controls the mix level of the Chorus effect.
Speed 0…127
Controls the LFO speed of the Chorus effect.
Depth 0…127
Controls the modulation depth of the Chorus effect.
Delay
w
This effect type is only available for the Effect 2 unit.
A Delay is an effect that produces echoes of the input
signal. An important feature of the Blofeld’s Delay effect is
that the Delay length can be changed without clicks or
pitch changes. This allows you to experiment with
different Delay lengths without getting annoying side
effects in the output signal.
Length 0...29
Sets the length of the Delay tap.
Spread -64...+63
Spreads the left and right delay output to half of the delay
time maximum. Settings from -64 or +63 create a typical
ping pong delay.