Waldorf Wave 3.v - Manual (Page 42)

The Controls
PPG Wave 3.V User´s Manual 42
SEMITONE 1-8 0...63
These parameters are directly connected to KEYBOARD
MODE in the DIGITAL panel (also see the section
“Keyboard Mode”). They are used to define the pitch of
the individual voices in the different play modes in
semitone steps. If you set a Semitone value to “0”, then
the corresponding semitone will wind up in the 32’
octave range. If you set it to “12”, it winds up in the 16’
octave range etc.
• SEMITONE 1 controls the pitch in POLY mode.
• SEMITONE 1 and 2 control the pitches in DUAL
mode.
• SEMITONE 1 to 4 control the pitches in QUAD
mode.
• SEMITONE 1 to 8 control the pitches in MONO
mode.
MODULATION Panel (MOD)
You can use the Modulation panel to make various
settings that concern the modulation sources and their
respective targets. The Modulation panel offers a fast
editable modulation table. To open the Modulation panel,
press the MOD button on the Plug-In panel. The button
lights up in blue.
The x-axis of the modulation table contains all
modulation sources. The y-axis contains the modulation
destinations. Click on a corresponding intersection to
activate the desired modulation or to change the
modulation amount.
Activate the FINE parameter button in the upper area to
add additional modulations that were not possible in the
original PPG Wave. It offers also more detailed
modulation amounts.