Waldorf Pulse 2 - Manual (Page 55)

Appendix
55 Pulse 2 User Manual
Receiving System Exclusive Data
You are not required to activate a special receive mode
of the Pulse 2 in order to receive system exclusive data
through MIDI or USB. However, there are a few things
you should check before you transmit system exclusive
data to the Pulse 2:
• Make sure none of the Pulse 2’s sounds is in edit
mode. The edit buffer might be cleared or over-
ridden depending on the type of dump that is
sent to the Pulse 2.
• Check out the parameter Device ID. Data trans-
mission will only be executed successfully if if
the sender and receiver settings match.
As soon as the dump from the sending device is acti-
vated, the Pulse 2 will receive data and store these in its
memory.
If a single sound dump is received, it is temporarily
stored in its respective edit buffer. If you want to keep
such edits, you have to store them. Otherwise they are
discarded when you switch the Pulse 2 off.