Component list – Weston Cuber/Tenderizer & Jerky Slicer Motor User Manual
Page 3
DIAGRAM NUMBER
PART DESCRIPTION
PART #
1 Motor Bracket 01-0104
2 Adapter
01-0105
3 Bracket Arm 01-0106
4 MG Wing Nut (2)
01-0107
5 110mm Hex Head Bolt (2) 01-0108
6 16mm Allen Head Bolt (2) 01-0109
7 Motor
01-0101
8 Allen Wrench 01-0111
COMPONENT LIST
4
9. Install the Bracket Arm onto the two 110mm Hex
Head Bolts. Screw the two Wing Nuts onto the bolts
and tighten until the Motor is secured in place.
Figure 7
Note: DO NOT over tighten the Wing Nuts, tighten
only enough to secure the motor in place. If the Wing
Nuts are to tight, the Motor may bind during use.
10. The unit is now fully assembled and ready for use. Be sure to read and
understand the instructions that came with your cuber/jerky slicer for safe
operation.
Wing Nut
Figure 7
Bracket
Arm
Fully assembled Motor
5
7
2
6
8
3
1
-6-
-3-
If any components of this unit are broken or the unit does not operate
properly, call Pragotrade Inc. Toll Free at
1-800-814-4895
Monday thru Friday 8:00am-5:00pm EST.
Outside the U.S. call 440-638-3131