Linksys E4200 - Manual (Page 54)

42
Improving Security Linksys E-Series
42
How do I know if my network is secure?
For ALL
If you configured your router using Cisco Connect, your network is secure .
During setup, Cisco Connect creates a name for your network, enables industry-
standard WPA/WPA2 wireless security, and assigns a highly secure password for
your wireless network and the administrator’s account .
To confirm that your network is secure:
1. Run Cisco Connect .
2. In the upper-right corner of the screen, check for the green light that
indicates your router is online and secure . If the green light is on, no
additional action is required to secure your network .
Network security following a manual
setup
For ALL
If you configured your router manually (not recommended), you must manually
configure security .
To manually set your router’s password:
Administration > Management
1. Log into the browser-based utility (see “How to open the browser-based
utility” on page 25) .
2. Click the Administration tab, then click the Management page .
3. In the Router Access section, enter a secure password for your router,
then re-enter the password to confirm it . Your password should be
at least eight characters in length . The most secure type of password
should include a mix of uppercase and lowercase letters, numbers, and
punctuation .
4. Click Save Settings at the bottom of the screen .
To manually set your router’s network name (SSID):
Wireless > Wireless Settings (E4200)
Wireless > Basic Wireless Settings (non-E4200)
1. Log into the browser-based utility (see “How to open the browser-based
utility” on page 25) .
2. Click the Wireless tab, then click the Wireless Settings page (for E4200
routers) or Basic Wireless Settings page (for non-E4200 routers) .
3. For Configuration View, select Manual .
4. Enter a new network name in the network name (SSID) field, then click
Save Settings at the bottom of the screen .
Improving Security