Safety, Important safety instructions – Epson PERFECTION V600 PHOTO User Manual
Page 10
Important Safety Instructions
Read all these instructions, and follow all warnings and instructions marked on the scanner.
In this document, warnings, cautions, and notes indicate the following:
Warnings
must be followed carefully to avoid bodily injury.
Cautions
must be observed to avoid damage to your equipment.
Notes
contain important information and useful tips on the operation of this product.
Place the scanner close enough to the computer for the interface cable to reach it easily. Do not place or
store the scanner or the AC adapter outdoors, near excessive dirt or dust, water, heat sources, or in
locations subject to shocks, vibrations, high temperature or humidity, direct sunlight, strong light
sources, or rapid changes in temperature or humidity. Do not use with wet hands.
Place the scanner and the AC adapter near an electrical outlet where the adapter can be easily
unplugged.
Caution:
Be sure the AC power cord meets the relevant local safety standards.
The AC power cord should be placed to avoid abrasions, cuts, fraying, crimping, and kinking. Do not
place objects on top of the AC power cord and do not allow the AC adapter or the power cord to be
stepped on or run over. Be particularly careful to keep the AC power cords straight at the end and the
point where it enters the AC adapter.
Use only the AC adapter that comes with your scanner. Using any other adapter could cause fire,
electrical shock, or injury.
The AC adapter is designed for use with the scanner with which it was included. Do not attempt to use it
with other electronic devices unless specified.
Use only the type of power source indicated on the AC adapter’s label, and always supply power directly
from a standard domestic electrical outlet with the AC adapter that meets the relevant local safety
standards.
When connecting this product to a computer or other device with a cable, ensure the correct orientation
of the connectors. Each connector has only one correct orientation. Inserting a connector in the wrong
orientation may damage both devices connected by the cable.
Avoid using outlets on the same circuit as photocopiers or air control systems that regularly switch on