Lenco CR-3306 BT - Manual (Page 12)

12
Using the night light
The device is equipped with a built-in night light. To turn on the night light, put the light
switch in the on position (14). To turn the night light off, put the light switch in the off
position (15).
Reset the device
When the device does not respond correctly or does not respond at all, it can be reset
by carefully pressing the Reset button with a paper clip. Please note that when the
device is reset all settings will be lost. If the device is still not responding properly after
the reset, disconnect the power adapter from the power outlet for 5 minutes.
Connections
Connecting a device through the AUX input
Every device with an AUX output or headphones output can be connected to the AUX
input. When the external device is connected through the AUX input, the volume can
only be controlled through the radio. Everything else can only be controlled on the
external device. To playback sound through the AUX input, the radio must be set in
the AUX mode. Do this by repeatedly pressing the source button (13) until AU is shown
on the AU op het display.
Charging a device through the built-in USB charger
To charge an external device, connect the device with mini USB to the built-in charger
(21). Once an external device is connected, it will start charging immediately.