Lenco DR-439 - Manual (Page 4)

Notes on CDs
·Before playing, clean the CD with a cleaning cloth. Wipe the CD from the center out.
·Do not expose the CD to direct sunlight or heat sources such as hot air ducts, not leave
it in a car parked in direct sunlight as there can be a considerable rise in temperature
inside the car.
·Do not stick paper or stickers on the CD, nor scratch the CD.
·After playing, store the CD in its case. If there is a scratch, dirt or fingerprints on the CD,
it may cause a tracking error or skipping.
Scratched Discs
If your disc is badly scratched, it will not play. You may be able to repair the disc if you
buy a disc polisher.
2.MAINTENANCE
Cleaning the Lens
If the lens becomes dirty, it may cause a skipping of sound during CD operation.
Clean with a commercially available lens cleaner and blower.
Cleaning the Cabinet
Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild
detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent,
such as alcohol or benzene
3.SPECIFICATION
Power source AC 230V
DC 9V (6 size ”C” batteries)
Speakers 4 ohm
Output power 2X2W RMS
Dimensions 360 X 270 X 160
Playable disc typerange CD/MP3 DISC
Radio Frequency FM:87.5-108 MHZ
DAB:174-240MHZ
Page 2 Page 7
8. LISTEN TO THE RADIO
In FM mode:
(1)Press SOURCE button to select FM mode.
(2)Press Up button /Down button to manually search for frequency
(0.05MHz) step by step.
(3)Press and hold the button or to search for the station automatically.
press again to stop searching.
(4)Press ST/MONO button to select ST or MONO that you want.
(5)Press the Volume + /Volume - to adjust your desired Volume level.
(6)Press and hold the power button to turn the unit to STANDBY mode.
In DAB mode:
(1)Press SOURCE button to select DAB mode.
(2)Press Up button /Down button to manually search for stations step by step.
(3)press and hold the Stop button to full scan from the lowest frequency to the
highest frequence for the strongest signal stations and all of the strongest
stations are stored.
(4)Press the FF/up , REW/down select the stored station after the full scan
operation..
(5)Press and hold the power button to turn the unit to STANDBY mode.
(6)In DAB mode, press INFO button to display the information of the current DAB
program.
8.1 Preset and store the station your want to listen to
In FM/DAB mode:
(1)To store the station your current listening, Press and hold the
Preset/Id3 button to activate the Preset function. The preset number
“*” will flash in the LCD. ( “*” represents Preset Number 1~20)
(2))Press the Album + /Album - to select the Preset Number you want to store
(3)Press the Preset/Id3 button to confirm your setting.
(4)Repeat step 1-3 to preset other stations.
(5)Press the Preset/Id3 button to recall the preset station. Use the
the Album + /Album - to select.
(6)Press the Preset/Id3 button or select button to listen to the
select stored stations.
(7)Press and hold the reset button for about 5 seconds to System reset mode.
All of the stored DAB and FM stations will be deleted.
1
18
12
12 18
18
18
1
8
16
5
5
14
4
4
7
3
3
14
14
16
16
14 16
12
13