Lenco iPD-1003 User Manual
Page 3
4 5
CONNECTING ILLUSTRATION
AUX IN
Follow below steps to connect the unit to another audio device like MP3 player and the like:
1. Connect the Audio Out of the device to AUX IN jack with audio cable.
2. Press the POWER button on the rear of the unit and then press STANDBY button to turn the unit on.
3. Press FUNCTION button on the unit repeatedly or press AUX IN button on the remote to switch the
unit to AUX IN mode.
4. Power on the device and begin playback.
VIDEO OUTPUT
1. Dock a iPod/iPhone or iPad to the unit.
2. Connect a RCA cable to the Video Out on the unit and Video in on a television.
3. Power on the TV set and the unit. Press FUNCTION button on the unit repeatedly or iPhone
button/iPad button on the remote to switch the unit to iPhone or iPad mode.
4. Adjust the connected television to the proper input setting. And press VIDEO ON/OFF button on the
remote for outputting the video.
5. Video from a docked iPhone/iPod/iPad can now be played through the unit to the connected
television.
COAXIAL INPUT
You will need: An audio source with a COAXIAL OUTPUT jack and coaxial audio cable.
1. Connect the Coaxial Audio Cable to the COAXIAL OUTPUT on the audio source and to the COAXIAL
INPUT on the unit.
2. Power on the unit and the audio source. Then press FUNCTION button on the unit repeatedly or
press COAXIAL IN button on the remote to switch the unit to COAXIAL IN mode.
3. Audio from the connected audio source will now be played through the unit.
Note: The unit is compatible with SPDIF PCM code only for the coaxial.
LINE IN
1. Use a 3.5mm audio cable to connect an MP3 player or other audio source to the LINE IN jacks on the
unit.
2. Power on the unit and the audio source.
3. Press FUNCTION button on the unit repeatedly or press LINE IN button on the remote to switch the
unit to LINE IN mode.
4. Audio played through the connected MP3 player or other audio source will now play through the unit.
DISC HANDLING PRECAUTIONS
Hold the disc by the edge so the surface will not be soiled with finger prints. Finger prints,
dirt and scratches can cause skipping and distortion.
Do not write on the label side with a ball-point pen or other writing utensils.
Do not apply benzine, thinner, and liquid that prevents against static electricity.
Be careful not to drop or bend the disc.
Install only one disc on the disc tray.
Do not try to close the disc tray when the disc is not installed properly.
Be sure to store the disc in its case when not in use.
IMPORTANT SAFETY INSTRUCTIONS
The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids,
such as vases, shall be placed on the apparatus.
When the mains plug or an appliance coupler is used as the disconnect device, the disconnect device
shall remain readily operable. To be completely disconnected the power input, the mains plug of the
apparatus or the appliance coupler shall be disconnected from the mains completely.
No naked flame sources, such as lighted candles, should be placed on the apparatus.
Minimum distances 2.0cm around the apparatus for sufficient ventilation. The ventilation should not
be impeded by covering the ventilation openings with items, such as newspapers, table-cloths,
curtains, etc.
The use of apparatus is in tropical and/or moderate climates.
Attention should be drawn to the environmental aspects of battery disposal.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
The marking plate is located at the back of the apparatus.
PECIFICATIONS:
Power source: AC 100V~240V 50/60Hz
Power consumption: 80W
Remote control: CR2025
Dimensions: 545.5(L) x 196.5(W) x 140(H) mm
Operating Humidity Range: 10 % to 75 %
If at any time in the future you should need to dispose of this product please note that:
Waste electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or retailer for recycling advice. (Waste
Electrical and Electronic Equipment Directive)
Video cable
Coaxial audio cable (optional)
Video in
Video out
Coaxial out
Coaxial in