Lenco iPOD TOWER 1 - Manual (Page 6)

SYSTEM CONNECTION
PC
DVD Player
Before connecting acoustic equipment, pay attention to the picture below.
Each connection must be safe and firm. Disconnect power cable until you have
finished all the connections.
FM antenna
PREPARATION
1) Before the unit is turned on, please check if all the connections are right and safe.
Then connect the main power.
2) Press the button on the back panel to turn on the main power.
3) Press the button on the remote control (or front panel) to exit the standby
mode.
POWER ON/OFF
STANDBY
STATE INDICTION OF DISPLAY SCREEN
1. In radio status, show the received frequency and mono/stereo.
2. In Audio-input, IPOD status, show the signal input and main volume status.
FAST FORWARD AND FAST REWIND
PREVIOUS AND NEXT
In play status, press the button to go to the previous audio file; press the
button to go to the next audio file.
Note: These buttons are unavailable in Audio Input mode.
BASIC OPERATION
MUTE BUTTON
STANDBY MODE
Press the
button on the remote control (or on front panel) to switch
ON/OFF the Standby mode.
Note: Make sure that the unit is connected to the power source.
STANDBY
SLEEP BUTTON
In play status, press the button on the remote control continuously, you can get
the different sleep time for this unit: 10 min, 20 min, 30 min, 60 min, 90 min, 120 min.
For example, if you press the
button to select ``10 min``, the unit will enter
sleep mode in 10 minutes.
SLEEP
SLEEP
5 6
VOLUME SETTING
Press the buttons to turn the volume up or down. VOL.+/-
In play status, press the or button to fast rewind or fast forward. Press the
button again or button to resume playing mode.
Note: These buttons are unavailable in Audio Input mode.
PLAY
If you press the button while playing, sound signal will not be heard. Press the
button again or the buttons to resume the previous volume level.
MUTE
MUTE VOL+/-