Lenco IPD-5200 - Manual (Page 7)

Eng Eng
13
Sleep Timer Function
Sleep to timer
This feature allows you to fall asleep to the radio or iPod for up to 120 Minutes.
The unit shuts off automatically when the time expires.
1. Press the POWER button to turn the unit on.
2. Either tune to the desired radio station in radio mode or playback music
from the iPod.
3. To select the sleep timer to turn the unit off after 15, 30, 45, 60, 90 or
120 minutes, press the SLEEP button repeately. The display show the
indicator . The unit plays for the selected length of time then
automatically turns off.
4. To turn the unit off before the sleep timer counts down to zero, press
the POWER button at any time.
Notes :
If you are falling asleep to music from an external device connected to the
AUX input, the sleep timer will shut off the power to this system but it will
not turn off the external device.
Wake to iPod or Radio
When the alarm time is reached, the selected alarm source (iPod or Radio)
will automatically turn on. It starts softly and gradually becomes louder.
It plays for 30 minutes then shuts off and resets itself for the following day.
During the activation of the alarm source, you may press the SNOOZE
button to activate the snooze function. The alarm stops for the snooze time
(around 10 minutes) then turns on again.
To cancel the snooze before it expires, press theALARM button.
This manual snooze operation can be repeated three times. Each time the
alarm turns on, it plays for 30 minutes (without pressing the snooze button).
To stop the alarm immediately after the alarm sounds, you may also press
the POWER button. It resets itself for the following day.
Or, when the alarm sounds, you may press the V / or T/CH /
button to continue listening the iPod / Radio, where the alarm will be disable.
12
Alarm Operation
When the unit is OFF (power off mode):
Select wake up alarm source
1. Press and hold the ALARM button until the alarm source indicator blink.
2. Press the T/CH / button to select alarm source BUZ (buzzer) ,
iPod or RAD (radio).
Setting the alarm time
3. Press the ALARM button again, alarm time digits blink.
4. Press the V / button to set alarm hour.
5. Press the T/CH / button to set alarm minute.
Save settings and activate alarm
6. To save all settings and exit the setting mode, press the SNOOZE button.
7. To activate the daily alarm, press the ALARM button and the
corresponding alarm source indicator appears on the LCD display.
Notes :
---If "Wake to iPod" is selected but your iPod has not been docked, the alarm
source will be redirected to the Alarm Buzzer automatically when the alarm
is reached.
---When "Wake to Radio" is selected, make sure the radio station which you
want to wake to is tuned.
Wake to Buzzer
When the alarm time is reached, the buzzer alarm will sound for 3 Minutes.
It goes into Auto-snooze mode if no further button has been pressed.
The display shows the "SNOOZE" indicator. The buzzer turns off for the
snooze time (around 10 minutes) then comes on again. This operation will
be repeated three times. After the fourth alarm is finished, the alarm will
shut off until the same alarm time on the next day.
You may also activate the snooze function manually after the alarm sounds
by pressing the SNOOZE button. The buzzer stops for the snooze time then
comes again.
To cancel the snooze before it expires, press the ALARM button.
The snooze operation (including auto-snooze and manual snooze) can be
repeated by 3 times only.
To stop the alarm immediately after the buzzer sounds, you can also press
the ALARM button. It resets itself for the following day.
IPD5200 iB.indd 12-13 2010-12-18 16:32:33