Lenco IR-1650 - Manual (Page 4)

Note: The encryption code would have been set up by the person who set up and configured your
network.
After 3seconds the display goes into the code entry mode or press select.
If the display does not automatically go into code entry mode, press the SELECT button. To enter
the code, use the DAIL to select each character of the code in turn, pressing the SELECT button
after each character.
3. Make sure the character you want is shown in the centre of the display to be able to select it.
4.If you complete the key then you can use “END” to confirm. The display shows “Connect WiFI” as the
radio connects to the network.
5.If the connecting is OK, it will show you
6.Now you can go to listen to the internet radio:
Changing the volume:
You can change the volume by turning the TUNE clockwise to increase the volume and anticlockwise to
decrease the volume. The display shows the volume bar. You cannot change the volume when you are
in a menu or when the radio is connecting to a station.
Step 2 How to set your radio
In the main menu, you will see below the settings.
By Region
By Genre
Stations
User
UPNP Servers
Playback Mode Repeat / Shuffle
Media
Player
Clear Queue
Scan for Networks
Enter network Name
View Config
Configure Network Config
Edit Config
< END <> 0 1234 >
Connect WiFi
Connecting /
Network OK
<Stations>
Media Player