Lenco L-83 - Manual (Page 5)

5
To protect the device during a thunderstorm, unplug the AC power
cable and disconnect the aerial. Caution: Do not touch the aerial (RF)
connector.
When the device is not in use for long periods, unplug the AC power
cable for safety reasons.
To clean the device, use a soft dry cloth. Do NOT use solvents or
petrol based fluids. To remove severe stains, you may use a damp
cloth with dilute detergent.
The supplier is not responsible for damage or lost data caused by
malfunction, misuse, modification of the device or battery replacement.
If the device will not be used for an extended period, please charge the
battery at least once per month to maintain battery life.
Safety instructions - continued
Charge the battery if:
a) The battery level icon displays (An empty battery)
b) The device switches off automatically when restarted.
Do not interrupt the connection when the device is formatting or
transferring files. Otherwise, data may be corrupted or lost.
The USB memory stick should be plugged into the unit directly.
Don’t use an USB extension cable because it can cause
interference resulting in failing of data.
Assembly
Drive belt:
The belt and turntable platter have been installed properly at factory, but
the belt may be loose during transportation. If so, the following procedures
will be taken for belt installation by yourself.
A.
Remove the rubber mat from the turntable platter and the E ring from
the turntable shaft, then release the turntable platter from the shaft
B.
Put the drive belt on the inner rim of the turntable platter and pull it
through the hole
C.
Hold the belt with your fingers and place the belt onto the motor pulley
as shown in the drawing.