Lenco MC-141 - Manual (Page 9)

GB 7
CD SECTION
Channels: 2 channels
S / N ratio: 60 dB
Wow & Flutter: undetectable
Sampling frequency: 44.1 kHz 8 x over sampling
Quantization: 16 bits DA converter
Pick up light source: Semi - conductor laser
Pick up wave length 790 nm
RADIO SECTION
Tuning ranges: FM 87.5 - 108 MHz
AM 522 - 1620 kHz
Antennas: AM Built - in ferrite bar
FM Wire antenna
GENERAL
Output power: 2 W + 2 W
Power consumption: 17 WATTS
Speaker: 3" 8 OHM
Phones jack: 3.5MM
Power source: AC : 230V ~ 50Hz
Dimensions
Main Unit: 175 (L) x 207 (D) x 133 (H)mm
Speaker: 110 (L) x 174 (D) x 133 (H)mm
Remote control: 35 (L) x 18 (D) x 190 (H)mm
Weight: 2.63 Kgs
Due to continuing improvement, the features and the design are subject to change without notice.
Where to place the item :
Today’s furniture is coated with a wide variety of lacquers and synthetic-coatings that are treated with an extensive range
of cleaning products. Therefore, the possibility that some of these substances contain components that react adversely to
the rubber feet of the item and soften them, cannot be completely excluded. The rubber feet of the appliance can cause
discoloring to furniture surfaces. If necessary, place the appliance on a non-slide surface.
If at any time in the future you should need to dispose of this product please note that Waste
electrical products should not be disposed of with household waste.Please recycle where
facilities exist. Check with your Local Authority or retailer for recycling advice.
(Waste Electrical and Electronic Equipment Directive)
SPECIFICATIONS
CLEANING CD
If the CD skips or will not play , the disc may
need cleaning. Before playing, wipe the disc
from the centre out with a cleaning cloth. After
playing, store the disc in its case.
MAINTENANCE
CLEANING THE UNIT
Do not use volatile chemicals on this unit. Clean by lightly
wiping with a soft cloth.
IMPORTANT NOTE
If an abnormal display indication or an operating problem
occurs, disconnect the AC power cord. Wait at least 5 seconds,
then reconnect the AC power cord.
WARNING
Should the CD door be opened before the reading of the CD
completed, a jamming noise may occur. This is resolved by
closing the CD door.
CLEANING THE CD LENS
If the CD lens is dusty, clean it with a brush-blower. Blow
several times on the lens and remove the dust with the brush.
Finger prints may be removed with a cotton swab moistened
with alcohol.
For information and support, www.lenco.eu