Lenco MC-144 - Manual (Page 5)

5
CD
• Before playing, clean the CD with a cleaning cloth. Wipe the CD from the center out.
• Do not expose the CD to direct sunlight or heat sources such as hot air ducts, not leave it in a car
parked in direct sunlight as there can be a considerable rise in temperature inside the car.
• Do not stick paper or stickers on the CD, nor scratch the CD.
• After playing, store the CD in its case. If there is a scratch, dirt or fingerprints on the CD, it may
cause a tracking error or skipping.
• If the player is brought directly from a cold to a warm location, or is placed in a very damp room,
moisture may condense on the lens inside the CD player section. Should this occur the player will
not operate properly. In this case, remove the CD and wait about an hour for the moisture to
evaporate.
• To be completely disconnect the power input, the mains plug of apparatus shall be disconnected
from the mains .As the disconnect devices is the mains plug of apparatus.
• The mains plug of apparatus should not be obstructed OR should be easily accessed during
intended use.
• This CD player is designed to be played on a stable no vibration position. If you bump the set
during CD play, the music will stop or skip for a few seconds. This is normal for this type of player.
Scratched discs
If your disc is badly scratched, it will not play. You may be able to repair the disc if you buy a disc
polisher.
Maintenance
Cleaning the Lens
If the lens becomes dirty, it may cause a skipping of sound during CD operation. Clean with a
commercially available lens cleaner and blower or carefully wipe it with a soft dry cloth.
Cleaning the Cabinet
Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent
solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as alcohol or
benzene.