Lenco MC-146 - Manual (Page 4)

Playing MP3/WMA CD
1. After reading the CD, the total number of folders (F) and tracks (T) will be shown on the LCD display (3). The unit will start to
play automatically with the first track in the first folder in alphabetical order.
2. Press “ Folder/ Pre (21) or Pre ” at remote control to select the folder number.
3. Press “ Skip Up
or Skip Down ” button (19) to select the next or previous track number.
ID3/Display function
Press the “ ID3 “ button (8) repeatedly, the LCD display (3) shows: “ file - … ”during playback of the MP3/WMA file. The song
file/album/song/artist name/clock time is being displayed in sequence. Press the “ ID3 ” button (8) again until the display shows
the running time to disable the function.
Remark:-
- In case of no name or a not supportive language has been assigned for the track, the LCD display will stay blank (3) when
pressing the ID3 button.
- No Title/Album name can be recognized if the disc format is not supported by the unit.
- The system supports only English and Arabic characters for the ID3 function.
MP3 track format requirement:-
- Bit rate : 32 kbps~320kbps, sample rate : 32khz, 44.1khz and 48 kHz decodable
- The performance of playing MP3 Disc varies, depending on the quality and method of the recording. Furthermore, the
searching lead-time for MP3-CD is longer than for an audio CD due to a different format.
Repeat/Random mode
Press the “ Play Mode ” button (9) during playback to select repeat and random function, a single track, all the tracks repeat or
folder repeat(MP3 only) and random can be played in difference mode as follow:-
For CD
(1) repeat 1 (2) repeat all tracks (3) random (4) repeat off mode
Indicator
Play mode on LCD display
Repeat track & flashing
Repeat all
Random RAN
Off mode --------------
For MP3/WMA Disc
(1) repeat 1 (2) repeat all tracks (3) repeat 1 folder
(5) off mode (4) random
Indicator
Play mode on LCD display
Repeat single track & flashing
repeat all tracks
Repeat single folder
Random mode RAN
Off mode
Repeat play means:
You can listen to the desired track or the entire disc repeatedly by using this function.
Random play means:
You can listen to all the tracks in a random order by using this function.
CD programming
Up to 20 tracks can be programmed for play in any order. Before use, be sure to press the “ stop ” button (17).
1. Switch to CD mode & stop the CD playback.
2. Press the “ Mem/Clk-Adj ” button (16) and “ MEM ” will appear on LCD display (3).
3. Select the desired track by pressing skip up
or down button (19).
E-3