Lenco MC-148 DAB+ - Manual (Page 15)

14
FM OPERATION
Switch to the FM mode.
SCANNING FOR STATIONS
1. You can scan up or down the frequency range manually by pressing the
 / buttons on the remote or pressing / buttons on the unit to
increase or decrease the frequency in 0.05MHZ increments. To scan
through the frequency range quickly press and hold the / buttons on
the unit or press the / buttons on the remote control.
2. Once a station has been found, the scanning will stop automatically. If
no station is found, then the tuning will stop once it has cycled through
the entire FM band (87.5-108MHz).
SCAN MODES
When performing a scan you can set the sensitivity level of the stations to
be found. E.g.: strong signals only or all stations.
1. In FM mode, press the STOP/MENU button, when <Scan Setting>
appears on the display press the ENTER or PLAY/PAUSE button to
view the submenu.
2. Use either  / on the unit, / on the remote to select either <All
Stations>
(which will detect any station, even with a weak signal) or
<Strong Station only>
(which will only detect stations with a good
signal strength). Press the ENTER or PLAY/PAUSE button to select the
required option.
3. When you perform a scan as described in above, only stations fitting the
applied setting will be detected.
STORING STATION PRESETS
It is possible to store up to 10 of your favorite stations.
This will enable you to access your favorite stations quickly and easily.
1. To store a preset, you must first be listening to the station that you would
like to save.
2. Then press and hold one of the numeric buttons from 1-0 to store the
station under that number. You will see Preset X Stored appear on the
display with X being the number you stored the station under.